Get Adobe Flash player
FacebookTwitterGoogle+
English Arabic French German Italian Portuguese Russian Spanish

Did you know?

The word engineering is derived from the Latin word ingeniere which means ingenious.
 

Help us stay online:

small donate

 

robot2In this example we will explain how to make your own IR system for remote control and you will see how that system can be applied for directing mobile robot (or similar processes).
System consists of transmitter and receiver. IR LEDs emit light on frequency that is detectable with commercial IR receiver. How system works? On picture you can see how is NE555 times used to modulate IR light at 36 kHz.

 

Read more...

There is not much info out there about the RCA protocol so I basically took a remote (an XBOX remote that uses the RCA protocol) and started analyzing the flow. I also had help from looking at the lirc remote archive.It is actually quite similar to the NEC protocol.

Read more...

ir remoteThe cheapest way to remotely control a device within a visible range is via Infra-Red light. Almost all audio and video equipment can be controlled this way nowadays. Due to this wide spread use the required components are quite cheap, thus making it ideal for us hobbyists to use IR control for our own projects.
This part of my knowledge base will explain the theory of operation of IR remote control, and some of the protocols that are in use in consumer electronics.

Read more...

This protocol is designed by Philips and transmitters are produced by Philips (SAA3008) and ST (M3004). Personally I have never seen this protocol being used in real applications. All information on this page is derived from the data sheet of the Philips SAA3008 and the ST M3004 (10624.pdf).

There are 2 small differences between the two competitor ICs. The Philips IC has two modes of operation, one which is compatible with the ST chip and one which can handle up to 20 sub-system addresses. The ST chip has the capability of switching the modulation carrier off.

Read more...